Klarstein AQUAFINA Bedienungsanleitung Seite 22

EN
CONTROL PANEL
This button is used to turn the water purifier on and off. In the
standby mode, if you press the button for 2 seconds, the water
purifier will switch to the working mode. In the working mode,
press and hold the "power" button for 2 seconds to put the
water purifier into standby mode.
This button is used to clean the internal waterways and water
tanks and drain the stored water.
This function is recommended for the first start-up, after
replacing the filter element and when restarting after a long
period of non-use. In operating mode, press and hold the
"Wash" button to start automatic cleaning. The whole process
takes 6 minutes.
These indicators are used to indicate the lifespan of the
particular filter element. When the indicator is white, it means
the status of the filter element is normal. If the indicator lights
up orange, it means that 80% of the filter element has been
used up. If the indicator is red, it means that the filter element
life has expired and it needs to be replaced.
After replacing the filter element, press the reset button to
start counting the life of the new filter element. In operating
mode, press and hold the reset button for 3 seconds. Then
immediately press the button to select the filter element whose
lifetime measurement needs to be reset. Press and hold the
button again to complete the filter element replacement.
This shows the operational status of the water purification
system of the water purifier. When the indicator is on, it means
the water treatment process is in progress. When the indicator
flashes, it means the filter element has been cleaned. After
completing these operations, the display is off.
22