Klarstein BAROSSA 77D Montageanleitung Seite 27

Reversibility of the door
1 Put the cabinet on open operation place, the door opened to the maximum angle.
2 Use small knife (2) to take off the decorative nail (1) on opposite side (Drawing 1).
3 Hold the door, use six angle screwdriver (3) to screw out the door shaft core (4)
from the two ends of the top of the door. Take out the door and set aside.
(Drawing 2)
4 Discharge the upper and lower door hinge (6/7) by M5 inner six angle
screwdriver (3). Then to assemble the door hinge on the opposite side.
(Drawing 3 and 4 )
5 Rotate the door 180°, then Install the door on the opposite side of the cabinet.
(Drawing 5)
6 Finally, install the decorative nail at the opposite side. (Drawing 6)
EN
27