Husqvarna 132HBV Bedienungsanweisung Seite 19

ee
an er eo
eRe ge ee ed
ae ee
ne nee a a ee gee a ED nee ee Rehan ee Oe Re met en met
€4 Starting instructions
Before Starting the Engine:
Fuel the engine. Move at least 3 m (10 feet) away from the fueling site.
Hold the tool in the starting position as shown. Make sure the blower end is
directed away from people, animals, glass and solid objects.
For a Cold Engine or a Warm Engine After Running Out
of Fuel
a.
b.
Cc.
a.
Move Ignition Switch (A) to the "On" position.
Move Choke (B) to "FULL" position.
Grasp handle and squeeze throttle trigger (C) fully. Hold throttle trigger thru
step "f".
Pull starter Rope sharply until engine attempts to run, but no more than 8
pulls on full choke.
The engine "attempts to run" may be hard to hear. The operator must listen
carefully. After 8 pulls, proceed to step "e" even if the engine has not
attempted to run.
Move Choke to "HALF" position.
Pull Starter Rope sharply until engine runs, but no more than 5 pulls.
NOTE: If engine has not started after 5 pulls, repeat steps "a" through "f'.
. Allow engine to run for 5 seconds, then move Choke to "OFF" position.
NOTE: If engine dies with Choke at "OFF" position, repeat steps "e" through
"g". If engine does not operate properly, refer to "Carburetor Adjustments".
To stop engine, move Ignition Switch to "OFF" position.
For a Warm Engine
=
a
22 oof
Move Igriition Switch to the "ON" position.
. Move Choke to "HALF" position.
Grasp handle and squeeze throttle trigger fully. hold throttle trigger thru step
Pull Starter Rope sharply until engine runs but no more than 5 pulls.
Move Choke to "OFF" position. NOTE: If engine does not run after 5 pulls, it
is probably flooded. Wait a few minutes and repeat procedure with Choke at
"OFF" position.
To stop engine, move Ignition Switch to "OFF" position.