Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Operating the Compressor Pump
WARNING: Do not operate the Compressor Pump for more than 10
minutes continuously. After operation allow it to cool down for 15
minutes.
Setting the desired pressure:
Use the pressure hose and, if needed, and adapter to connect the
compressor pump to the valve of the item to be inflated.
Press a button to activate the display. Press the Button (9) multiple
times o select the desired unit of pressure and then set the pressure
with the + and – buttons. After a few seconds the display will switch to
the current pressure.
When the trigger switch is now operated the object will be filled with the
set pressure.
Service
WARNING: Always disconnect from the mains power supply, before
carrying out any maintenance/ cleaning of the charger. Remove the
battery before carrying out any maintenance/cleaning of the tool.
Note: Both the tool and the charger contain no user-serviceable parts.
If the device does not perform as outlined in this manual, turn to the
Westfalia customer service or to a competent professional.
General Inspection
Inspect the supply cord of the charger for damage or wear prior to each
use. Repairs should be carried out by an authorised service centre.
This advice also applies to extension cords used with this tool.
Battery Disposal
1. Run motor until the battery is completely discharged.
2. Remove the battery from the tool.
3. Wrap heavy insulating tape around the battery terminals or enclose
in a sealable plastic bag to prevent possible shorting.
4. Dispose of the battery through your local waste removal authority.
19
Werbung
