Electrolux CI1201 Benutzerinformation Seite 6

6 www.electrolux.com
3.2 Switching on
• Insert the plug into the wall socket
• Turn the Temperature regulator
clockwise to a medium setting.
The pilot light will light up
If the temperature inside the appliance is
too high the Alarm light will blink. Active
the FastFreeze function.
3.3 Switching off
To turn off the appliance, turn the
Temperature regulator to the "O"
position.
The pilot light will switch off.
3.4 Temperature regulation
The temperature is automatically
regulated.
To operate the appliance, proceed as
follows:
• turn the temperature regulator
toward lower settings to obtain the
minimum coldness.
• turn the temperature regulator
toward higher settings to obtain
the maximum coldness.
A medium setting is
generally the most suitable.
However, the exact setting
should be chosen keeping in
mind that the temperature
inside the appliance
depends on:
3.5 FastFreeze function
You can activate the FastFreeze function
by pressing the FastFreeze switch.
• room temperature
• how often the door is
opened
• the quantity of food
stored
• the location of the
appliance.
The FastFreeze light will light up.
This function stops
automatically after 52 hours.
It is possible to deactivate
the function at any time by
pressing FastFreeze switch.
The FastFreeze light will
switch off.
3.6 High temperature alarm
An increase in the temperature in a
compartment (for example due to an
power failure) is indicated by flashing of
the Alarm light.
When normal conditions are restored the
Alarm light will switch off automatically.
3.7 Acoustic alarm
An acoustic alarm will sound when the
temperature inside the freezer has risen
to a point where the safe storage of
frozen food is no longer ensured.
When normal conditions are restored,
the acoustic alarm will stop.
In any case, press the Alarm
reset switch to deactivate
the acoustic alarm.
3.8 Door open alarm
An acoustic alarm will sound when the
door is left open for around 80 seconds.
When normal conditions are restored
(door closed), the acoustic alarm will
stop.
In any case, press the Alarm reset switch
to deactivate the acoustic alarm.