Electrolux CI1201 Benutzerinformation Seite 11

Problem
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FastFreeze function
is switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The FastFreeze or Shop‐
ping Function function is
switched on.
The temperature regula‐
tor is not set correctly.
The food products' tem‐
perature is too high.
The door has been
opened often.
The FastFreeze function
is switched on.
There is no cold air circu‐
lation in the appliance.
ENGLISH
Solution
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to "Closing the door".
The compressor starts after
a period of time.
Switch off FastFreeze or
Shopping Function manually,
or wait until the function re‐
sets automatically to set the
temperature. Refer to "Fast‐
Freeze or Shopping Function
function".
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Open the door only if neces‐
sary.
Refer to "FastFreeze func‐
tion".
Make sure that there is cold
air circulation in the appli‐
ance.
11