Kenwood P-66 Bedienungsanleitung Seite 5

Assembly
@ How to set the turntable platter
and rubber mat
1 Set the turntable platter carefully on the
center spindle.
2 Using the ribbon tape, engage the drive belt
with the motor pulley as shown.
Drive belt
Ribbon tape
Motor pulley
Ribbon tape
Drive belt
Turntable platter
3 Remove the ribbon tape.
@ Take care not to twist the drive belt.
4 Place the rubber mat onto the platter.
Se Dat ots
: =
sl
@ Be sure that the auto size detector can be seen through
the slit of the rubber mat.
@ Using the armrest hook
Tonearm
@ The hook should be fastened when the player is not in
use.
Remove the viny] tie
After connection and set up, remove the vinyl tie holding the
tonearm.
Using the stylus cover
Before operation, raise the stylus cover in the direction of the
arrow.
Stylus cover
After record play, always lower the stylus cover to protect the
stylus tip.
Stylus cover
P-66 (En) 7
m
z
q)
Cc
77)
x