Philips HD5410 Bedienungsanleitung Seite 8

EnglisH
8
12 After you have poured coffee, put the jug with the remaining coffee back on the hotplate to
keep it hot (Fig. 10).
- For your convenience and safety, this appliance is equipped with an auto shut-off function. It
shuts itself off automatically after one hour. This also prevents the coffee from becoming too
bitter.
- However, coffee is at its best directly after it has been brewed (Fig. 11).
Drip stop
The drip stop prevents coffee from dripping through the filter onto the hotplate when you:
- remove the jug from the appliance for a moment (max. 30 seconds) towards the end of the
brewing process.
- remove the jug after the brewing process has finished.
after drinking coffee
1 Open the filter holder support (Fig. 12).
2 Lift the filter holder with the filter out of the filter holder support (Fig. 13).
3 Throw away the used paper filter with the coffee grounds (Fig. 14).
If you have used a permanent filter, empty it and rinse it under the tap.
making another jug of fresh coffee right away
If you want to make another jug of fresh coffee right away, switch off the appliance and let it cool
down for three minutes. Fill the water tank again with cold water and put a new amount of ground
coffee in the filter. Now you can make fresh coffee again.
Note: If you do not let the appliance cool down for three minutes before you brew coffee again,
water starts dripping into the filter holder right away.
- Make sure you pour the first amount of fresh water against the temperature sensor in the
centre of the water tank disc (Fig. 15).
When you do this, the outflow opening in the bottom of the water tank closes again.
cleaning
Always unplug the appliance before you start to clean it.
Never immerse the appliance in water.
1 Clean the outside of the coffeemaker with a moist cloth.
2 Clean the detachable parts in hot water with some washing-up liquid or in the dishwasher.
Only the coffee jug and the filter holder can be cleaned in the dishwasher.
3 Clean the rubber insert in the outflow opening of the water tank every month and after
every descaling procedure. (Fig. 16)
Do not forget to put the insert back into place before you use the appliance again.
Never remove the rubber insert if there is still hot water in the water tank.
Do not clean the water tank with a moist cloth. Regular descaling keeps the inside of the water tank
clean.
Descaling
This unique brewing system is extra sensitive to scale build-up. Regular descaling is therefore
important.
In case of normal use (two brewing cycles a day), descale your coffeemaker:
- every two months if you use soft water (up to 18dH);
- every month if you use hard water (over 18dH).