Kärcher R 100 Bedienungsanleitung Seite 7

Test mode display
Tie rod nuts
1
Tie rod
2
Sweeping pattern
1
1. Wet an appropriately large floor area with chalk and run the
cleaning head over it.
2. Switch on the cleaning head, lower it and brush briefly on the
chalk surface.
3. Lift the cleaning head and remove it from the chalk surface.
4. Check sweeping pattern for uniformity and parallelism, adjust
if necessary.
Hooking the relief springs
Note
The number of relief springs required depends on the respective
brush head:
Brush head
D 100
R 100
R 120
Bolt
1
Relief spring
2
Eyebolt
3
Hexagon nut M8
4
Note
For easy installation, the brush head suspension should be in the
upper end position.
1. Hook the relief spring into the eyebolt.
2. Secure the eye bolt on the frame with the M8 hexagon nut.
3. Hook the relief springs onto the bolt.
Note
Use a cable tie to tension the relief spring and hook it onto the
bolt.
Check for correction function
1. Plug in the KIK on the control panel.
2. Push the safety switch into position "I".
3. Turn the program switch to the position "Scouring / preclean-
ing without vacuuming" (see operating instructions).
4. Check driving and cleaning result.
English
Number of relief springs
0
3
4
7