Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SETTING FURTHER CHANNELS
Antenna settings and searching
for digital channels from a satel-
lite automatically
Notes:
The following description about the LNB
7
settings premise a substantial expertise
about the satellite systems. Ask your
specialist dealer.
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP«
with »
« or »
« and press »OK« to
V
Λ
confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
and press »OK« to confirm.
Select the input source »Satellite« with »
>
»
«, »
« or »
« and press »OK« to
V
Λ
confirm.
4 Select the line »Antenna Settings« with »
or »
« and press »OK« to confirm.
Λ
– The menu appears.
5 Select and set the required option for the
antenna settings with »
Satellite
Press »OK« then select the required satel-lite
<
>
with »
«, »
«, »
V
»OK« to confirm.
LNB Type
Press »OK« then select the required LNB
<
>
Type with »
« or »
data and confirm with » « (green).
LNB Power
Set the LNB power supply (depending on
the type of LNB) to »Off« »13/18 V« or
<
»14/19 V« with »
LNB Selection
Only necessary for »DiSEqC 1.0« or
»DiSEqC 1.1«, see chapter "Searching for
antenna settings for DiSEqC 1.0/1.1 and
digital channels from a satellite automati-
cally".
6 Select »Auto Tuning« by presing » « (red).
Television / User Manual
« or »
«
V
Λ
<
«,
V
« or »
«:
V
Λ
« or »
« and press
Λ
«, enter the required
>
« or »
«.
-----------------------------------------------------
7 Select the line »Scan Mode« with »
»
«.
Λ
Select the scan mode with »
(for unencrypted channels, for encrypted
channels only, or both).
8 Select the line »Service Type« with »
»
«.
Λ
<
Use »
« or »
to search for television channels (TV) only,
radio stations only (Radio) or both
(Radio + TV).
9 Start the scan with » « (red).
– The »Results« menu appears, and the scan
for TV channels begins.
Notes:
When updating via the same satellites a
7
security query is displayed at the start of a
search.
If the previously stored channels should
7
be retained in the channel list and the new
«
channels found be added to it, then press
» « (green).
If » « (red) is pressed, the saved channels
7
will be deleted from the current channel list.
– The »Results« menu appears, and the scan
for channels begins.
– Depending on the number of channels
received, this can easily take a few
minutes.
– The search is complete as soon as the
»PROGRAM TABLE« appears.
Note:
You can abort the search by pressing
7
»MENU«.
10 Press »MENU« to end the setting.
V
<
>
« or »
>
« to select whether you want
EN 80 / 63
« or
«
« or
V
Werbung
Inhaltsverzeichnis
