Tensioning The Steel Cable; Releasing The Tension Of The Steel Cable; Cleaning, Maintenance And Storing - Westfalia 94 46 89 Originalanleitung

to be pulled and press down the release spring (1).

Tensioning the Steel Cable

1. Press down the release spring (1) again in order to hook the release
hook (2) back into the rack wheel (3).
2. Operate the lever up and down in order to tension the steel cable.

Releasing the Tension of the Steel Cable

1. To release the tension of the steel cable, lift up the release spring (1).
2. Hold the lever (9) down until the release hook (2) pushes the locking
hook (4) up and disengages the locking hook (4). Now the rack wheel
(3) is moving free and by operating the lever back, the tension will be
released by one notch of the locking hook (4).
3. Operate the lever up and down in order to release the tension one
notch at a time.
WARNING: While releasing the tension, avoid abrupt lever move-
ments. Only apply even and steady pressure to the lever! Never re-
lease the locking hook while the load is not properly secured!
Maintenance, Cleaning and Storing
 If the hand power puller is used extensively, it should be examined and
lubricated by a qualified technician once a year.
 Do not try to repair the hand power puller yourself and do not disas-
semble it. Have the hand power puller repaired by a professional only.
 Clean the housing of the hand power puller with a lightly moistened
cloth.
 Before undertaking any inspection or maintenance work on the hand
power puller, make sure the power puller is released. Do not work on
the power puller under load!
 Keep the steel cable clean and well lubricated. Lubricate the cable from
time to time by applying a thin layer of grease resp. spray a thin layer of
Operation
18