Intended Use; Slacken The Tension Of The Steel Cable - Westfalia 94 46 89 Originalanleitung

Intended Use


The hand power puller is designed for moving and pulling freely
moving (rolling/swimming/sliding) within the limits that are specified in
the technical data. The hand power puller must not be used for moving
fixed loads and for lifting loads.

The intended use also includes an operation following the operating
instructions. Any use beyond these parameters (different media, apply-
ing force) or any changes (reconstruction, no original accessory) can
lead to serious risks and is regarded as use that is contrary to the
intended purpose.
Before each operation, secure the load against rolling.

Slacken the Tension of the Steel Cable

1. Make sure the safety
hook (5) resp. The safety
hook with the pulley is
anchored to a sturdy
point.
2. Lift up the release spring
(1) in direction to the
arrow.
3. Lift the lever (9) and hold it in position so the release hooks (2)
release the rack wheel (3). Press the catch of the locking hook (4)
from behind and below. Thus the rack
wheel (3) is free. Now the steel cable is
slackened.
4. Hook one end of the power puller on a
rigid anchoring point and pull the hand
power puller up to the desired length.
While unwinding the steel cable make sure
that at least three winding will remain on
the cable drum!
5. Hook the other safety hook (5) on the load
Operation
17