KERN ODC-87 Serie Betriebsanleitung

KERN ODC-87, ODC 88
Version 1.0 01/2016
GB
User instructions
Microscope camera ( eye p i e c e c a m e r a )
Before use
You should ensure that the device is not exposed to direct sunlight,
temperatures which are too high or too low, vibrations, dust or a high level of
humidity.
The ideal temperature range is between 0 and 40°C and a relative humidity of
85% should not be exceeded.
Always make sure that you use an approved power cable. Thus possible
damages by reason of the development of overheating (fire hazard) or an
electric shock can be prevented.
Do not open the housing and touch the internal component. There is the risk of
damaging them and affecting the functionality of the camera.
In order to carry out cleanings always disconnect the power cable from the
camera.
Always keep the sensor clear from dust and do not touch it. Otherwise there is
the risk of affecting the microscopic image. In case of non-use always attach the
protective covers.
Technical data
Model
Resolution Interface Sensor
KERN
ODC 872
1,3 MP USB 2.0 1/3" CMOS
ODC 874
3,1 MP USB 2.0 1/2,7" CMOS
1/2,5" CMOS
ODC 881 5,1 MP USB 3.0
ODC-87_88-BA-e-1610
Frame rate Colour / Supported operating
Mono- systems
chrome
7,5 – 12,5 fps Colour Win, XP, Vista, 7, 8, 10
3 – 7,5 fps
Colour Win, XP, Vista, 7, 8, 10
15 -30 fps Colour Win, XP, Vista, 7, 8, 10
Scope of delivery
-
Microscope camera
-
USB cable
-
Object micrometre for calibration
-
Software CD
Free download:
www.kern-sohn.com > DOWNLOADS > SOFTWARE > Microscope VIS Basic / Pro
-
Adjustment rings (Ø 30,0 mm + Ø 30,5 mm) for eyepiece adapter
Mounting
1. Remove the black cover at the bottom of the camera.
2. The round connecting piece, where the cover was attached, has a
standardised diameter (Ø 23.2 mm). Thus the camera suites all
microscopes of which the eyepieces have this standard size.
3. For the mounting to the microscope one of the eyepieces needs to be
removed from the microscope tube and replaced by the eyepiece
camera.
Important:
For microscopes, that have a different eyepiece diameter (30.0 mm
or 30.5 mm, mostly used for stereo microscopes), you need to apply
the appropriate adjustment ring in order to mount the eyepiece
camera correctly.
4. If necessary, adjust the microscope according to the trinocular usage (with
help of the trino toggle rod / trino toggle wheel).
PC connection
1. Establish USB connection via USB cable.
2. Installing the software with help of the CD.
Detailed instructions can be found in the supplied "readme"-file.
3. Both the supplied "Help"-files and the software-internal "User Guide"
include all information and instructions about the operation of the
software or of digital microscopy.