Um die Waffel aus dem Waffeleisen entnehmen zu können, muss regelmäßig vor Einfüllen des Teiges die Backplatte eingefettet werden. Wir empfehlen Schneider-Backtrennspray. Gießen Sie den Teig auf die Bodenplatte und warten Sie 1 Minute, dann legen Sie die obere Platte nach unten und backen die Waffeln ca.
2.3. Programmieren im Zählmodus Mit dem programmierbaren Timer können Sie Ihre Zeit im Count-Up-Modus pro- grammieren. Dies ist praktisch, wenn Sie die Zeit, die Sie zum Backen der Waffeln benötigen, vor der Programmierung messen müssen. Wenn Sie mit dem Backen begonnen haben, drücken Sie die Taste „+“, um den Timer zu starten.
1. INSTALLATION Take out the waffle maker from the packaging and locate the unit on a firm level surface. When this appliance is to be positioned in close proximity to a wall, partitions, kitchen furniture, decorative finished, etc., it is recommended that they be made of non-combustible material, if not, they shall be clad with a suitable non-combusti- ble heat-insulating material, and that the closet attention be paid to fire prevention regulations.
2.2. Programming the timer Remind: The timer will not automatically shut off your unit. Once your programmed time has lapsed, the unit will beep 5 times and the screen will go blank. Program manually To manually program the timer, hold both “-” and “+” at the same time for four se- conds.
Seite 7
1. The power supply is correct and the thermostat is turned on. 2. The position of thermostat are correct. 6. BASIC SPECIFICATION Code Voltage Power Dimension 150700 „Quadro“ 220 – 240 V / 50 / 60 Hz 1600 W 420 x 300 x 295 mm 150710 „Herz“...
Seite 8
Schneider GmbH In der Längerts 1 D -73095 Albershausen Phone: +49 (0) 71 61 / 30 04 -0 Fax: +49 (0) 71 61 / 30 04 -50 Email: info@schneider-gmbh.com www.schneider-gmbh.com...