Outwell CARNELIAN DC 350 Bedienungsanleitung

CARNELIAN DC
MODEL: 651073 / ZY - 901M - R ( CARNELIAN DC 350 )
MODEL: 651071 / ZY - 901L - R ( CARNELIAN DC 600 )
6. MICRO USB CHARGE INPUT
7. USB OUTPUT
5. BOTTOM HANGING HOOK
8. CHARGE INDICATOR
1. REMOVABLE LAMPSHADE
4. HANGER
3. BUTTON
2. BATTERY COMPARTMENT LID
UK: INSTRUCTION MANUAL
Light modes:
• Press the button (3.) to turn the lamp
on or off.
• Press and hold the button to dim
the light. The light can be dimmed
stepless to any setting between min.
and max.
Use of the lamp:
• Lamp is charged using 5V DC USB
power outlet. Micro USB input is
located under protective lid (6.)
• Charging cable is included with the
lamp. Lamp have built in overcharge
protection circuit.
• When charging the charging indicator
(8.) lights red. When fully charged the
indicator lights green.
• Please fully charge the lamp before use.
• Lamp can also be used as power bank
to charge phones etc. USB output is
located under protective lid (7.)
• Lamp can be used standing, hanging
from the hanger (4.) or hanging from
the bottom hook (5.)
• When hanging from the bottom
hook, the removeable lampshade can
be removed by rotating it counter-
clockwise.
• Lamp can be cleaned with water or a
damp rag.
• Lamp is water resistant to IP44.
• Do not use corrosive liquids to clean
the lamp.
• Do not stare into the light source.
• Do not modify the product.
Light source: LED
Carnelian DC 350 contains a light source
of energy efficiency class G.
Carnelian DC 600 contains a light source
of energy efficiency class E. Light source
and control gear is not replaceable. This
would introduce weak points
in the construction, that
could reduce the lifetime of
the product.
Instruction for removal of light
source and control gear by market
surveillance authorities:
1) Remove lamp shade by hand, rota-
ting it counterclockwise.
2) Remove battery compartment lid by
rotating it counterclockwise.
3) Remove 4 screws to allow removal of
black inner battery lid.
4) Pull out battery cradle including
switch PCB and light source PCB
including heat sink.
5) Cut wires to light source PCB, and pry
off light source PCB.
Instruction for disassembly of lamp
for disposal of components
when lamp has reached the
end of its usable life:
- See steps 1-5 above
6) Cut wires to allow removal of
battery. Dispose of battery according
to local regulations.
7) Cut wires to allow removal of charge
port electronics on circuit board and
switch circuit board. Dispose of elec-
tronics according to local regulations.
8) Dispose of remaining components
according to local regulations.
Technical data (Carnelian DC 350):
3.7V , 6W
Input: 5V , 1A
Output: 5V , 1A
Battery: 3.7V , 2200mAh
Class 3 appliance
Technical data (Carnelian DC 600):
3.7V , 10W
Input: 5V , 1A
Output: 5V , 1A
Battery: 3.7V , 4000mAh
Class 3 appliance