Herunterladen Diese Seite drucken

Werbung

Aufbauanleitung / assembly instructions mod.
S342 - S344 mit Frontauszug
4x
30 x 10,5
4x
M10
1.Montagematerial.
2. Fitting material.
M10 x 610
3. Die kurzen Gewindestangen einschrauben, so
dass sie gegenüber der anschweißten Mutter
etwa 7 mm vorstehen.
3. Screw in the short threaded bolts, so that they
stick out of the welded-on screw approximately
7 mm.
S342 - S344 mit Frontauszug
2x
2x
M10 x 610
M10 x 708
1x
SW17
2. Den Oberbau umgedreht auf gepolsterten
Montageböcken ablegen.
2. Put the table-top upside down onto padded
assembling trestles.
!
4. Die beiden Rollen des Unterbaus der Auszugs-
seite abschrauben. Zuerst die Rolle mit der
Achse abziehen und dann das Rollengehäuse
abschrauben.
4. Unscrew both rolls of the base of the extension
side. Take off the roll and the spindle and then
unscrew the roll housing.
1 / 5
Änderungsdatum: 21.04.21

Werbung

loading

Inhaltszusammenfassung für Schöner Wohnen Kollektion S342

  • Seite 1 Aufbauanleitung / assembly instructions mod. S342 - S344 mit Frontauszug M10 x 610 M10 x 708 30 x 10,5 SW17 1.Montagematerial. 2. Den Oberbau umgedreht auf gepolsterten 2. Fitting material. Montageböcken ablegen. 2. Put the table-top upside down onto padded assembling trestles.
  • Seite 2 8. Vor dem Ausziehen auf beiden Seiten die 7. Turn the table. schwarzen Bremsschrauben lösen. 8. Before the extension can be pulled out, the two black screws must be released. 2 / 5 S342 - S344 mit Frontauszug Änderungsdatum: 21.04.21...
  • Seite 3: Rechte Seite Einstellen

    10c: Die Klappeinlage mit dem Ledergriff aus- 10c. Swing out the table-extension by using the klappen, die Höhe rechts erneut leather belt. Check the hight again; if kontrollieren und wenn nötig erneut necessary adjust again. einstellen. 3 / 5 S342 - S344 mit Frontauszug Änderungsdatum: 21.04.21...
  • Seite 4: Linke Seite Einstellen

    11c. Swing in both pieces of the table-extension at the same time. Use the leather-blet to swing out the table- extension and check the hight again. If necessary, adjust again. 4 / 5 S342 - S344 mit Frontauszug Änderungsdatum: 21.04.21...
  • Seite 5 12. Fertiger Tisch; nicht ausgezogen. 12. Finished table; not extended. 13. Fertiger Tisch; ausgezogen. 13. Finished table; extended. 5 / 5 S342 - S344 mit Frontauszug Änderungsdatum: 21.04.21...

Diese Anleitung auch für:

S343S344