KONG Italy 829.000 Produktspezifische Anweisungen

8 - SPECIFIC INFORMATION
The Personal Protective Equipment Category III 829.000 "RE-
FLEX" is:
- a sheave mounted in plates used to link a rope or an accessory
cord to a connector reducing the friction while the rope or
accessory cord is moving under load;
- part of a system protecting/preventing against impact caused
by fall from a height;
- certified according to EN12278:2007 and conform to
UIAA127:2018.
Fig. 1 – Rope attachment – To attach the device to a rope
insert a suitable connector in the eyelets (A) and then make the
rope pass through the plates (B) and above the sheave.
Fig. 2 – Mobile pulley – This device can be used for lifting
loads with mechanical advantage.
Fig. 3 – Walking on the line – This device can be attached
directly without making passing through of the rope end.
Fig. 4 – Quickness – This device can be easily readily for
creating tackles.
Fig. 5 – Examples of wrong and dangerous use.
Fig. 6 – Force composition - By reducing the deflection in a
rope (therefore widening the angle), the forces acting on the
anchoring points exponentially increase.
Compatibility – This device has been designed to be used
with:
- connectors according to EN362 and/or EN12275;
- rope lanyards according to EN354
- slings according to EN566;
- accessory cords according to EN564;
- ropes according to EN892 or EN1891.
When assembling the system check that the rope does not
touch the metal plates nor can be placed between the sheave
REFLEX
829.000 - REFLEX
EN 12278:2007 - UIAA 127:2018
and the plates.
Pre and post use checks – Before and after use, make sure
that the device is in an efficient condition and that it is working
properly, in particular, check that:
- it is suitable for the intended use;
- has not been mechanically deformed;
- does not show cracks, wear, corrosion and oxidation;
- the sheave rotate freely;
- markings are legible.
Before use and in a position that is completely safe, on each
occasion check that the device holds correctly by putting your
weight on it.
Important:
- the maximum diameter of suitable rope is 13mm;
- MBS (Minimum Breaking Strength) of the device is 26kN;
- pay attention to the rope course and possible obstacles it can
encounter.
Warning:
- use this device exclusively with the rope between the closed
plates secured by a connector;
- particular conditions (e.g.: heat, cold, wet, ice, oil, dust) affect
or interfere with the performances of this device.
NOMENCLATURE • NOMENCLATURA
A
B
EN: (A) Main eyelet, (B) Plate.
IT: (A) Occhiello principale, (B) Piastra.
FR: (A) Œillet principal, (B) Plaque.
DE: (A) Hauptöse, (B) Platte.
ES: (A) Ojal principal, (B) Placa.
NOMENCLATURE • TERMINOLOGIE • NOMBRES
Master text
1
ROPE ATTACHMENT
A
2
ATTACHMENT TO THE MIDDLE OF THE ROPE
3
QUICK ASSEMBLY TACKLES!
4
5
0,7kN
B
0,7kN 1kN 1kN
60˚ 120˚
1kN 1kN
A
180˚
∞kN ∞kN
1kN