Herunterladen Diese Seite drucken

Forma Lighting ZERO DUE 40 Installationsanleitung

Werbung

INSTALLATION INSTRUCTION
ISTRUZIONI DI MONTAGGIO
INSTALLATIONSANLEITUNG
INSTRUCTIONS D'INSTALLATION
INSTRUCCIONES DE MONTAJE
ZERO DUE
40 / 66 / 100 / 130
Wall/Ceiling Mounted Lighting
Apparecchio da parete/plafone
Anbau-Wandleuchten
Applique/Plafonniers
Luminaria para pared/techo
CAUTIONS
AVVERTENZE, WARNUNG
PRECAUTIONS, PRECAUCIONES
1. Switch-o the power supply before any
installation and maintenance operations.
Use only a two-pole switch
Staccare la linea elettrica prima
dell'installazione e di ogni
intervento di manutenzione.
Utilizzare un interruttore bipolare
Die Stromzufuhr muss vor der Installation /
Wartung ausgechaltet werden.
Nur mit einen zweipoligen Stecker zu verwenden
Couper la source d'alimentation avant toute
installation et opéation d'entretien.
Seulement utiliser avec un connecteur bipolaires
No efectuar la conexión de la lámpara con la
tensión general activada.
Usar un interruptor bipolar
2. Installation must be carried out only by qualified
personnel according to safety norms and local
regulations.
L'installazione deve essere e ettuata da
personale qualificato secondo la normativa
elettrica vigente.
Die Installation muss nach den gütigen
Sicherheitsvorschriften durch einen
konzessionierten Elektroinstallateur erfolgen.
L'installation doit etre realisée par un électricien
qualifié en respectant les prescriptions en
vigueur.
La instalación debe ser realizada por una
Art.
persona cualificada y de acuerdo a la normativa
vigente.
1421
1431
3. Use this light fixture at the rated voltage and
1432
frequency as indicated on the specification
1433
table.
Utilizzare questo apparecchio a tensione e
frequenza indicate nella tabella.
Die Leuchte darf nur mit der angegebenen
Spannung und Frequenz betrieben werden.
Respecter les prescriptions de tension et de
fréquence indiquées dans le tableau final.
Utilice esta lámpara a la tensión y frecuencia
indicadas en las instrucciones.
4. This installation manual must be retained by
the person responsible for the installation and
maintenance of the product.
Queste istruzioni di montaggio devono essere
conservate dal responsabile dell' installazione e
manutenzione dell' apparecchio.
Bewahren Sie diese Gebrauchsanweisung für den
verantwortlichen Benutzer / Wartungstechniker
auf.
Gardez cette instruction pour I'utilisateur /
technicien de maintenance.
Estas instrucciones deben ser conservadas
por el responsable de mantenimiento de la
instalación.
V.001

Werbung

loading

Inhaltszusammenfassung für Forma Lighting ZERO DUE 40

  • Seite 1 Die Installation muss nach den gütigen INSTALLATION INSTRUCTION Sicherheitsvorschriften durch einen ISTRUZIONI DI MONTAGGIO konzessionierten Elektroinstallateur erfolgen. INSTALLATIONSANLEITUNG L'installation doit etre realisée par un électricien INSTRUCTIONS D’INSTALLATION qualifié en respectant les prescriptions en vigueur. INSTRUCCIONES DE MONTAJE La instalación debe ser realizada por una Art.
  • Seite 2 INSTALLATION INSTALLAZIONE, MONTAGE, INSTALLATION, INSTALACIÓN Art. Art. Art. 1421 1431 1432 1433 V.001...
  • Seite 3 ANGLE ADJUSTMENT ORIENTAMENTO DEL VANO OTTICO, ORIENTERUNG DER OPTISCHEN, ORIENTATION DU GROUPE OPTIQUE, ORIENTABILIDAD DE LA OPTICA 350° 90° V.001...
  • Seite 4 MEASUREMENTS SPECIFICATION Class DIMENSIONI, ABMESSUNGEN, CARATTERISTICHE, BESCHREIBUNG, DIMENSIONS, MEDIDAS CARACTERISTIQUES, ESPECIFICACIONES in mm Volt.(V) Art. Lamp Remarks Class Wattage(W) /f(Hz) Zero Due 40 Surface 220-240V 1421 50/60Hz Art.: 1421 220-240V 1431 50/60Hz 220-240V 1432 50/60Hz 220-240V Ø42 1433 50/60Hz LED and remote LED driver included.

Diese Anleitung auch für:

Zero due 66Zero due 100Zero due 130142114311432 ... Alle anzeigen