TOUCH-1G TOUCH-2G TOUCH-4G TOUCH-TX2
AREA TOUCH / TOUCH AREA
AREA TOUCH / ZONE TOUCH
TOUCH-2G
TOUCH-1G
TOUCH-4G
TOUCH-TX2
Filo bianco
Pulsante filare
White wire
Wired button
Weißer Draht
Verkabeltem Taster
Fil blanc
Bouton filaire
BATTERIA / BATTERY
BATTERIE / BATTERIE
1
2
P1
P2
C
1.1
DESCRIZIONE
Radiocomando rolling code 433.92 MHz
TOUCH-1G: 1 canale con funzione settabile
TOUCH-2G: 2 canali con funzione settabile
TOUCH-4G: 4 canali con funzione settabile
TOUCH-TX2:
1 canale con funzione settabile
2
PROGRAMMAZIONE DEL TRASMETTITORE
Con questa procedura si programma un canale per abbinarlo a una ricevente compatibile.
Per eseguire la seguente procedura è necessario accedere alla ricevente.
PROCEDURA:
1- Attivare la ricevente sulla quale si vuole utilizzare il trasmettitore in modalità
"programmazione radio di trasmettitori generici" e selezionare la funzione che
si desidera abbinare al tasto (vedi il manuale della ricevente)
2- Fare una pressione con il tasto desiderato, il led della ricevente emette
tre lampeggi per segnalare l'avvenuta ricezione.
3- Il trasmettitore torna allo stato di stand by.
1.1
PRODUCT FEATURES
Remote control rolling code 433.92 MHz
TOUCH-1G: 1 channel with settable function
TOUCH-2G: 2 channels with settable function
TOUCH-4G: 4 channels with settable function
TOUCH-TX2: 1 channel with settable function
2
TRANSMITTER PROGRAMMING
This procedure is used to programme a channel in order to then associate it with a
compatible receiver. Access to the receiver is required to carry out the following procedure.
PROCEDURE:
1- Activate the receiver on which you want to use the transmitter in "radio programming of generic
transmitters" mode and select the function that you want to associate with the key
(see receiver manual).
2- Press the desired key; the receiver's LED flashes three times
to signal it has been received.
3- The transmitter goes back into stand-by.
1.2
DATI TECNICI
IT
Alimentazione
Batteria CR 2450
Durata batteria
Circa 3 anni
Codifica
Rolling code
Frequenza radio
433.92 MHz ISM
Portata
100 m (interno di edifici: 40 m)
Dimensioni
40 mm x 40 mm h 10 mm
1.2
TECHNICAL DATA
EN
Power supply
Battery CR 2450
Battery life
About 3 years
Code
Rolling code
Radio frequency
433.92 MHz ISM
Range
100 m (40 m inside buildings)
Dimensions
40 mm x 40 mm h 10 mm