HUBER+SUHNER 11_QMA-W50-2-6 Montageanleitung

Assembly instruction Series QMA 0000263508
11_QMA-W50-2-6
Connector type:
SM-86 , MF-86
Suitable cables:
Parts list connector:
Assembly steps:
Picture
The cable assembly of R.F. connectors can only be done by well trained assembly stuff and suitable assembly equipment.
Huber+Suhner's skilled stuff and specialised equipment are available to carry out complete R.F. lead-assembly on your behalf.
We mount your connectors on cables at economic prices! Please contact our representative for further details of this service.
Process
For SM cable
The tool must be set for a
stripping dimension of 3.9mm.
3.9
For SM cable
3.9
Prepare cable according to
2.2 diagram.
Form tip of inner conductor to
a 90° cone.
Dimension 11mm applies to
cable with jacket.
For Multiflex cable
Dive the on length cutted
cable in flux and tin.
Remove cable dielectric and
tinned braid according to
3.9
diagram.
2.2
Form tip of inner conductor to
a 90° cone.
Mount locator tool W360 M
onto body A. Insert cable into
connector body A. Remove
locator tool W360 M.
Push connector A completely
against locator tool W 456.
Solder connector A to cable.
Immediately cool down and
clean with alcohol.
Slide shrink tube B over
body A and shrink close to
connector body A.
Inner conductor contact:
Outer conductor contact:
Feature / Check
Cut cable end perpendicular
to cable axis.
Do not damage inner
conductor, dielectric and
braid.
The solder must flow at
behind for min. 8 mm.
If the cable does not fit into
the cable entry, use a flat-
nose pliers to calibrate the
braid.
Avoid excessive heat.
Promptly swap soldered area
with alcohol to cool joint and
remove any residual flux.
Avoid excessive heat.
Deutscher Text: siehe Rückseite
Plugged
Soldered
Tools required
Stripping tool W 157.
See instruction sheet No. 9144
(DOC-0000199604) for detailed
description.
Blades (74_Z-0-0-68)
Blades (74_Z-0-0-68)
flat-nose pliers
Locator tool W360 M
Soldering fixture
W 58 or W 442
Inserts W 60 (SM-86)
Inserts W 364 (MF-86)
Locator tool W 456
Hot-air fan
Revision A
Date 22.09.2008
Initiator 4884/TIS