Herunterladen Inhalt Inhalt Diese Seite drucken

Justfit 7640409890029 Bedienungsanleitung

Verfügbare Sprachen

PRODUCT INTRODUCTION
Temparature control
PRODUCT PARAMETERS
Product
Model
Product size
Charging voltage
Suction strength
Rated power
OPERATIONAL GUIDELINES
Preparation before use
Please read the safety precautions carefully when using this product. If it does not
meet the use conditions, this product is disabled.
It is recommended to clean and moisturize the skin with a wet towel or spray to
improve the sense of use experience.
Tighten and install the transparent tank (wipe the instrument with wet towel before
and a er use).
Check whether the instrument is complete and normal.
Power /mode
Press and hold for 1.5 seconds to start the machine, the LCD displays the 20-minute
countdown, and the temperature indicator lights up. The machine is equipped with
20-minute timing and automatically shuts down a er 20 minutes.
Press and hold for 1.5 seconds to shut down, and the LCD and temperature indicator
will go out.
In the power-on state, short press to change the mode. The machine has two modes,
deep negative pressure mode and soothing mode (Breathing pattern).
The default startup mode is deep negative pressure mode, and the negative
pressure function and heating function are automatically turned on.
Pressure relief / pause
Suction strength
Power / mode
6-Gear charging
7640409890029
90mm90mm78mm
5V 2A
-60~0kPa
5W
Air Inlet
Transparent pot
Type-C Charging Interface
Inhaltsverzeichnis
loading

Inhaltszusammenfassung für Justfit 7640409890029

  • Seite 1 Pressure relief / pause Air Inlet Temparature control Suction strength Transparent pot Power / mode Type-C Charging Interface PRODUCT PARAMETERS 6-Gear charging Product 7640409890029 Model 90mm90mm78mm Product size 5V 2A Charging voltage -60~0kPa Suction strength Rated power OPERATIONAL GUIDELINES Preparation before use •...
  • Seite 2: Temperature Control

    Suction strength • The power on defaults to the third gear strength. • Short press to adjust the suction strength, 0 Gear is o [negative pressure function]. • Each short press will increase 1 gear upward, and the LCD will display the corre- sponding strength gear.
  • Seite 3: Présentation Du Produit

    Entrée d’air Contrôle de la température Force d’aspiration Réservoir transparent Alimentation / mode Port de charge Type-C PARAMÈTRES DU PRODUIT 6-Gear charging Produit 7640409890029 Modèle 90mm90mm78mm Dimensions du produit 5V 2A Tension de charge -60~0kPa Force d’aspiration Puissance nominale ORIENTATIONS OPÉRATIONNELLES Préparation avant utilisation...
  • Seite 4: Contrôle De La Température

    Force d'aspiration • L’intensité par défaut au démarrage est le niveau 3. • Appuyez brièvement pour régler l’intensité d’aspiration; le niveau 0 désactive la fonction de pression négative. • Chaque pression augmente d’un niveau, et l’écran LCD a che le niveau correspon- dant.
  • Seite 5: Produktvorstellung

    PRODUKTVORSTELLUNG Druckentlastung / Pause Lufteinlass Temperaturregelung Saugkraft Transparenter Behälter Ein-/Ausschalten / Modus Typ-C-Ladeanschluss PRODUKTPARAMETER 6-Gang-Ladung Produkt 7640409890029 Modell 90mm × 90mm × 78mm Produktabmessungen 5V 2A Ladespannung -60~0kPa Saugkra Nennleistung BETRIEBSANLEITUNG Vorbereitung vor der Benutzung • Bitte lesen Sie die Sicherheitshinweise sorgfältig durch. Bei Nichtbeachtung oder ungeeigneten Bedingungen darf das Produkt nicht verwendet werden.
  • Seite 6: Temperaturkontrolle

    Saugkra • Die Standardintensität beim Einschalten ist Stufe 3. • Drücken Sie kurz, um die Saugintensität einzustellen; Stufe 0 deaktiviert die Unter- druckfunktion. • Jeder Tastendruck erhöht die Stufe um eins, das LCD zeigt die entsprechende Stufe an. Nach 1 Sekunde wird erneut der 20-Minuten-Countdown angezeigt. •...

Inhaltsverzeichnis