KERN ODC-82 Betriebsanleitung

KERN ODC-82, ODC-83, ODC-84
Version 1.3 0 9 /2023
User instructions
GB
Microscope camera
Before use
You should ensure that the device is not exposed to direct sunlight, temperatures
which are too high or too low, vibrations, dust or a high level of humidity.
The ideal temperature range is between 0 and 40°C and a relative humidity of
85% should not be exceeded.
Always make sure that you use an approved power cable. Thus, possible
damages by reason of the development of overheating (fire hazard) or an electric
shock can be prevented.
Do not open the housing and touch the internal component. There is the risk of
damaging them and affecting the functionality of the camera.
In order to carry out cleanings always disconnect the power cable from the
camera.
Always keep the sensor clear from dust and do not touch it. Otherwise, there is
the risk of affecting the microscopic image. In case of non-use always attach the
protective covers.
Technical data
Model
Resolution Interface Sensor
KERN
ODC 825
5,1 MP USB 2.0 1/2,5" CMOS
ODC 831
3,1 MP USB 3.0 1/3" CMOS
ODC 832 5,1 MP USB 3.0 1/2,5" CMOS
ODC 841 20 MP USB 3.0 1" CMOS
ODC-82_83_84-BA-e-2313
Frame rate Colour / Supported operating
Mono- systems
chrome
6,8 -55 fps Colour Win, XP, Vista, 7, 8, 10
27,3 – 53,3 fps Colour Win, XP, Vista, 7, 8, 10
14,2 – 101,2 fps Colour Win, XP, Vista, 7, 8, 10
15 - 60 fps Colour Win, XP, Vista, 7, 8, 10
Scope of delivery
-
Microscope camera
-
USB cable
-
Object micrometre for calibration
-
Software CD
Free download:
www.kern-sohn.com > DOWNLOADS > SOFTWARE > Microscope VIS Pro
-
Eyepiece adapter (Ø 23,2 mm)
-
Adjustment rings (Ø 30,0 mm + Ø 30,5 mm) for eyepiece adapter
Mounting
1. Remove the black cover at the bottom of the camera.
2. The thread, where the cover was attached, is a standardised C mount
thread. Thus, there are special C mount adapters needed for the
connection to a microscope.
3. For the mounting to the microscope the C mount adapter is attached
to the connection point of the microscope. After that the camera has
to be screwed onto the C mount adapter.
Important:
The choosing of the right C mount adapter depends on the used
microscope model. It must be an adapter, which is adjusted to the
construction of the microscope and recommended by the
manufacturer as appropriate for the relevant microscope.
4. If necessary, adjust the microscope according to the trinocular usage
(with help of the trino toggle rod / trino toggle wheel).
PC connection
1. Establish USB connection via USB cable.
2. Installing the software with help of the CD / Download.
3. The software-internal "User Guide" includes all information and
instructions about the operation of the software or of digital
microscopy.