Lezyne MICRO STVZO 300+ Bedienungsanleitung

74321-A1
MANUAL - EN -
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new Lezyne LED light. Traffic laws manda�ng
ligh�ng vary from country to country. Inform yourself about ligh�ng laws and regula�ons in the country of use. Lezyne LED lights
do not conform to the German road traffic regula�on StVZO.
Warnings
DO NOT LOOK DIRECTLY INTO LIGHT BEAM or shine into eyes of another.
Lezyne LED Lights have a water resistance ra�ng of IPX7 under IEC standard 60529. Submerging the device is not recommended. If
moisture does enter the casing, air out un�l completely dry.
DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void warranty.
Lezyne USA Inc. does not accept any liability for injuries or other damages resul�ng from the use of this product in any circumstances.
Warranty
In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the original purchase date to the original owner (proof of
purchase required). Lezyne Ba�eries carry a six (6) month warranty from the original purchase date. Lezyne warran�es cover any
manufacturing defects in materials or workmanship. Issues not covered by warranty include normal wear & tear, improper
installa�on, a�emp�ng to access or modify electronics, damage or failure due to accident, misuse, abuse and/or neglect.
For all warranty issues worldwide, please contact the retailer that sold the product.
For any warranty ques�ons contact: warranty@lezyne.com
Mounting
The light must be mounted in a height between 400 mm and 1200 mm. It must be ensured that the light technical equipment
will not be covered by any parts of the bike (�re, etc...).
Between
400 mm
and
1200 mm
MICRO STVZO 300+
HECTO PRO STVZO 400+
Operation
1. On/Off: hold bu�on two (2) seconds.
2. Mode cycle: click bu�on
MODE MEMORY: The light remains in the output se�ng it is switched OFF in.
THERMAL PROTECTION: If the opera�ng temperature of the light is too high, the light automa�cally lowers the lumen output.
Run Times and Modes
MICRO STVZO 300 +
ECONOMY BLAST
220 300
LUMENS LUMENS
4:30 2:45
h : min h : min
Power Pack +
Compatible
HECTO PRO STVZO 400 +
ECONOMY BLAST
250 400
LUMENS LUMENS
4:00 2:45
h : min h : min
Power Pack +
Compatible
Battery Indicator
An LED, located in the bu�on, displays current ba�ery status while light is ON. When light is OFF, click bu�on once to
momentarily display ba�ery status.
100%
Illuminates green
Charging
Before using your Lezyne LED Light for the first �me, fully charge the ba�ery.
To charge your light:
1. Switch light OFF
2. Remove USB-C protec�ve cover
3. Connect USB-C cable and light to powered USB-C port
4. Once charging, bu�on will flash green
If bu�on does not flash when plugged in, selected USB-C port may not be powered—try another USB-C port.
Light will be charged a�er 4–7 hours or when bu�on illuminates solid green or blue.
5. Remove light from charger and reinstall USB-C protec�ve cover—ensure USB-C protec�ve cover is fully installed for water
resistance.
Charging
Flashes green
More Information
For more informa�on on Lezyne products, visit:
Lezyne USA, 645 Tank Farm Rd., Unit F, San Luis Obispo, California 93401
MICRO STVZO 300+
HECTO PRO STVZO 400+
MICRO STVZO 300+
MICRO STVZO 300+
50%
Illuminates yellow Illuminates red
or red/green
Fully Charged
Illuminates green
www.lezyne.com
74321-EMANUAL FOR Y17 MICRO DRIVE STVZO 300+HECTO PRO STVZO 400+ -EN-R0A1
HECTO PRO STVZO 400+
HECTO PRO STVZO 400+
10%
USB-C Cable Not Included
Floor