Seite 1
Aufbauanleitung / assembly instructions mod. 2924, 2925 RENO mit Frontauszug Bitte diese Aufbauanleitung sorgfältig aufbewahren! Please keep this assembly instructions safe! 90/10/10 M10 x 60 M10 x 90 M6 x 30 Unterbau Holzsäule Holzsäule Metallstreben 1.Montagematerial (befindet sich in der Holzsäule). 1.
Seite 2
90/10/10 3. Die 4 Aluminium Distanzstücke auf die Schiene auflegen. 3. Put the 4 Aluminium distance pieces onto the frame. M10 x 60 4. Vier Schrauben ausdrehen und aufbewahren. Die Spanplatte entfernen. 4. Uncrew four srews and keep them. Throw away the chipboard. 2 / 8 2924, 2925 RENO mit Frontauszug Änderungsdatum: 15.06.23...
Seite 3
M10 x 90 5. Die Verstärkungsklötze auf die Bodenplatte schrauben. 5. Screw the supporting blocks onto base plate. M10 x 60 6. Die Bodenplatte mit der Holzsäule verschrauben. Die zweite Spanplatte abschrauben und entfernen. 6. Screw the base plate to wooden column. Unscrew the second chipboard and throw away. 3 / 8 2924, 2925 RENO mit Frontauszug Änderungsdatum: 15.06.23...
Seite 4
M6 x 30 7. Den Unterbau nun auf die 4 Alu-Distanzstücke stellen und verschrauben. 7. Now put the base onto the 4 alu-distancepieces and screw on. 8. Den fertig montierten Tisch wenden. 9. FertigerTisch, nicht ausgezogen. 8. Turn the assbled table. 9.
Seite 5
10. Vor dem Ausziehen auf beiden Seiten die schwarzen Bremshebel lösen. 10. Before the extension can be pulled out, the two black levers must be released. 5 / 8 2924, 2925 RENO mit Frontauszug Änderungsdatum: 15.06.23...
Seite 6
Klappeinlage in der itte einstellen / adjust the extension in iddle 11. Prüfen ob die Oberkanten des Auszugs und der Hauptplatte innen auf einer Höhe sind. Nur wenn nicht … 11. Check in the middle if the upper surfaces of the board and the extension are on one level.
14. Prüfen ob die Oberkanten des Auszugs und der Hauptplatte außen auf einer Höhe sind. Wenn nicht … 14. Check at the outer sides, if the upper surfaces of the board and the extension are on one level. If not ... echte Seite einstellen / adjust the ight side: schwarze Stellschrauben...
inke Seite einstellen / adjust the eft side: 16a. Die Klappeinlage fassen und beide Teile 16b. … und beide Halbteile umklappen. gleichzeitig vorsichtig hochklappen... Die Höhe mit einem Kreuz-Schraubendreher 16a. Grab both pieces of the table-extension an den schwarzen Laschen einstellen. and swing out both pieces of the table- 16b.