Nedco VoorVentilatie CR100T Einbauanleitung

VoorVentilatie TM | 's-Gravenweg 346 | 2911 BK Nieuwerkerk a/d IJssel | The Netherlands
Installation instruction bathroom / restroom fan CR100T
Switch off the power supply before you start.
1. Remove the round caps by lifting the caps by means of a flat screwdriver.
You will find the caps on the front of your fan, in the centre.
2. Remove the front by removing the screws with a Philips screwdriver.
3. Lead the wiring by means of which the fan should be connected through one of the
round openings (left and right) of the fan.
4. Mount the fan to the wall, in the corners of the fan you can see slots
through which the screws can be inserted.
5. Now connect the 3 cords of the wiring in accordance with the wiring diagram below,
From left to right
Zero = blue wire
Circuit = black wire
Phase = brown wire
Caution, if the fan is connected differently from what is described above, you run the risk that the fan will not function
properly!
6. Then you adjust the timer function. The button that you can use to adjust the timer function can be found on the top left side
of the circuit board and can be recognised by a white adjusting screw. The timer function can be adjusted between 1 and 30 minutes.
Turn the white adjusting screw fully counter-clockwise for a delay time that is as short as possible.
Turn the white adjusting screw fully clockwise for a delay time that is as long as possible.
7. Once the required delay time has been adjusted, you place the front back on the fan.
Then fasten the screws in the fan again and close them by placing the round caps back on the screws.
Your fan is now ready for use. You can now reconnect the power supply.
VoorVentilatie
TM
Safety conditions
This fan meets all standards and directives imposed by the EU that apply to electrical appliances. This fan should be installed by
a recognised installer. Installing a fan in a room where the ambient temperatures exceed the stated values of 40˚C and in a
room containing a mixture of air and hazardous gases is prohibited. Running the fan when there is a possibility that the fan
blades are damaged or hindered is not desirable. Precautions should be taken so that no backflow can occur of gases into the
room due to open fire and fuel-fired appliances. Prior to installing, the main power supply should be switched off. Accumulated
dirt and grease could eventually lead to short-circuiting, therefore clean the fan at least once every quarter.
Warranty:
The manufacturer guarantees a 24 month life span after the sales date, when used normally. Here, the safety conditions, the
correct handling of transport, storage, installation and use of the fan must be complied with.
When the fan breaks down due to an error in production within this warranty period, the fan will be replaced by a new fan
without any costs. The costs for renewed installation are not compensated. In case of ambiguities in relation to the correct sales
date, the production date shall apply.
| CR120T | CR150T