Herunterladen Inhalt Inhalt Diese Seite drucken

HANSGROHE ShowerTablet Select 400 24340 9 Serie Gebrauchsanleitung, Montageanleitung

Werbung

EN Instructions for use / Assembly instructions
DE Gebrauchsanleitung / Montageanleitung
2
3
ShowerTablet Select 400
24340XX9
ShowerTablet Select 400
24360XX9

Werbung

Inhaltsverzeichnis
loading

Inhaltszusammenfassung für HANSGROHE ShowerTablet Select 400 24340 9 Serie

  • Seite 1 EN Instructions for use / Assembly instructions DE Gebrauchsanleitung / Montageanleitung ShowerTablet Select 400 24340XX9 ShowerTablet Select 400 24360XX9...
  • Seite 2: Installation Instructions

    English Safety Notes Symbol description Gloves should be worn during installation to prevent crushing and cutting Do not use silicone containing acetic acid! injuries. Safety Function (see page 5) The product may only be used for bathing, hygienic and body cleaning purposes. The desired maximum temperature for example max. 42°C can be pre-set thanks to Children as well as adults with physical, mental and/or sensoric impairments the safety function. must not use this product without proper supervision. Persons under the influence Adjustment (see page 4) of alcohol or drugs are prohibited from using this product. The product may not be used as a holding handle. A separate handle must be After the installation, the output temperature of the thermostat must be checked. A installed. correction is necessary if the temperature measured at the output differs from the The hot and cold supplies must be of equal pressures. temperature set on the thermostat. Installation Instructions Maintenance (see page 7) • Prior to installation, inspect the product for transport damages. After it has been • The check valves must be checked regularly according to EN 806-5 in accord- installed, no transport or surface damage will be honoured. ance with national or regional regulations (at least once a year). • The pipes and the fixture must be installed, flushed and tested as per the • To guarantee the smooth running of the thermostat, it is necessary from time to applicable standards. time to turn the thermostat from total hot to total cold. • The plumbing codes applicable in the respective countries must be observed. • During installation of the product by qualified trained personnel, make sure that Dimensions (see page 6) the entire fastening surface is even and smooth (no protruding seams or tile Flow diagram (see page 6)
  • Seite 3: Sicherheitshinweise

    Deutsch Sicherheitshinweise Symbolerklärung Bei der Montage müssen zur Vermeidung von Quetsch- und Schnittverletzungen Kein essigsäurehaltiges Silikon verwenden! Handschuhe getragen werden. Safety Function (siehe Seite 5) Das Produkt darf nur zu Bade-, Hygiene- und Körperreinigungszwecken eingesetzt werden. Dank der Safety Function lässt sich die gewünschte Höchsttemperatur von z. B. Kinder, sowie Erwachsene mit körperlichen, geistigen und / oder sensorischen max. 42 °C voreinstellen. Einschränkungen dürfen das Produkt nicht unbeaufsichtigt benutzen. Personen, Justierung (siehe Seite 4) die unter Alkohol- oder Drogeneinfluss stehen, dürfen das Produkt nicht benutzen. Nach erfolgter Montage muss die Auslauftemperatur des Thermostaten überprüft Das Produkt darf nicht als Haltegriff benutzt werden. Es muss ein separater werden. Eine Korrektur ist erforderlich wenn die an der Entnahmestelle gemessene Haltegriff montiert werden. Temperatur von der am Thermostaten eingestellten Temperatur abweicht. Große Druckunterschiede zwischen den Kalt- und Warmwasseranschlüssen Wartung (siehe Seite 7) müssen ausgeglichen werden. Montagehinweise • Rückflussverhinderer müssen gemäß EN 806-5 regelmäßig in Übereinstimmung mit nationalen oder regionalen Bestimmungen auf ihre Funktion geprüft werden • Vor der Montage muss das Produkt auf Transportschäden untersucht werden. (mindestens einmal jährlich). Nach dem Einbau werden keine Transport- oder Oberflächenschäden aner- • Um die Leichtgängigkeit der Regeleinheit zu gewährleisten, sollte der Thermostat kannt. von Zeit zu Zeit auf ganz warm und ganz kalt gestellt werden. • Die Leitungen und die Armatur müssen nach den gültigen Normen montiert, gespült und geprüft werden. Maße (siehe Seite 6) • Die in den Ländern jeweils gültigen Installationsrichtlinien sind einzuhalten.
  • Seite 4 SW 27 mm X + 38 mm SW 3 mm SW 3 mm (3 Nm)
  • Seite 5 SW 3 mm for example 42°C z. B. 42°C SW 3 mm (1 Nm)
  • Seite 6 0,20 0,15 0,15 0,10 0,10 0,05 0,05 0,00 0,00 Q = l/min 9 12 15 18 21 24 27 30 Q = l/min 9 12 15 18 21 24 27 30 Q = l/sec Q = l/sec www.hansgrohe.com/cleaning-recommendation Cleaning recommendation / Warranty / Contact Reinigungsempfehlung / Garantie / Kontakt...
  • Seite 7 SW 3 mm SW 22 mm SW 22 mm SW 3 mm (4 Nm) (3 Nm) Red / Rot > 40 °C...
  • Seite 8 95758000 94403XX0 98372000 98368000 (M6x16) (M28x1,5) 92934000 98140000 92340000 98367XX0 (20x1) ShowerTablet Select 400 24360XX9 95772000 95773000 96429000 98282000 98371000 98913000 (29x3) 92136000 98199000 94405XX0 (17x2) 94404000 95758000 98368000 94403XX0 (M28x1,5) 92839000 98140000 98372000 92340000 (20x1) (M6x16) 98367XX0 Hansgrohe · Auestraße 5 – 9 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440 E-Mail: info@hansgrohe.com · Internet: www.hansgrohe.com...

Diese Anleitung auch für:

Showertablet select 400 24360 9 serie

Inhaltsverzeichnis