Troubleshooting - Klarstein BARZONA 2 Bedienungsanleitung

TROUBLESHOOTING

Trouble Reasons
phenomenon
The main gas valve has
not been opened.
Jet blocked.
The hose stave or bend.
Cannot ignite
There is air in the hose
when change cylinder.
Put the saucer in wrong
position.
Red flame Air humidity and smoke
is too big.
Yellow Some feculence in the
flame hole of burner cap.
The gas in the cylinder is
going out.
Backfire Pressure is too low.
flame
short
Something overflow the
hole of burner cap or
there is feculence.
Time of burning is too
long.
Gas pressure is too low.
Voice of flame out The speed of flame out is
is too big. too fast.
Solutions
Open the main gas
valve.
Dredge the jet.
Change the hose or
remove bend.
Repeat ignition for
several times.
Correct the saucer
position.
Ordinary phenonemon
Clean the burner cap.
Change the cylinder.
Check whether there
is gas in the cylinder
and the calve has been
opened or damaged.
Clean the burner cap.
Paused and use again
after cooling.
Check whether there
is gas in the cylinder
and thecalve has been
opened or damaged.
Slow the speed down.
EN
17