Automatic Shutdown Function; Maintenance; Maintenance Schedule - Husqvarna 120iTK4-H Bedienungsanweisung

2. Hold the housing (B) tight.
3. Push and hold the lock buttons (A) at the 2 sides of
the housing (B).
4. Move the cutting attachment to the correct angle.
5. Release the lock buttons (A) at the 2 sides.
6. Move the housing (B) up and down until the cutting
attachment locks in position.
To start the SavE function
The product has a SavE function. The SavE function
gives the longest operation time from the battery.
1. Push the SavE button. The LED comes on to show
that the function is on. (Fig. 41)
2. Push the SavE button again to stop the SavE
function.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.
1553 - 008 - 31.10.2022

Maintenance

Read and understand the
Remove the battery before

Automatic shutdown function

The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
60 seconds.
To stop the product
1. Release the power trigger.
2. Push and hold the start/stop button until the green
LED goes off.
3. Remove the battery from the product. Push the 2
release buttons and pull out the battery. (Fig. 42)

Maintenance schedule

The following is a list of the maintenance steps that you
must do on the product.
13