Product Liability; Symbols On The Battery And/Or On The Battery Charger; Safety; Safety Definitions - Husqvarna 110iL Bedienungsanweisung

yyyywwxxxxx The rating plate or the la-
ser printing shows the seri-
al number. yyyy is the pro-
duction year and ww is the
production week.
Symbols on the battery and/or on the
battery charger
Recycle this product at a recy-
cling station for electrical and
(Fig. 16)
electronic equipment. (Applies
to Europe only)
(Fig. 13) Fail-safe transformer.
(Fig. 14) Use and keep the battery charger indoors
only.

Safety definitions

Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
Used if there is a risk of
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General power tool safety warnings
WARNING:
and all instructions. Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious injury.
Note:
Save all warnings and instructions for future
reference. The term "power tool" in the warnings refers
to your mains-operated (corded) power tool or battery-
operated (cordless) power tool.
6

Safety

Used if there is a risk of
Read all safety warnings
(Fig. 15)
Double insulation.

Product liability

As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.
Manufacturer
Husqvarna AB
SE-561 82, Huskvarna, Sweden
Check before starting
• Always remove the battery to prevent the product
being started by accident. Always remove the battery
before any maintenance on the product.
• Before using the product and after any impact,
check for signs of wear or damage and repair as
necessary.
• Inspect the working area. Remove all loose objects,
such as stones, broken glass, nails, steel wire, string
etc. that could be thrown out or become wrapped
around the cutter or cutter guard.
• Check the motor for dirt and cracks. Clean off grass
and leaves from the motor using a brush. Gloves
should be worn when necessary.
• Check that the trimmer head is completely attached
to the trimmer.
• Check that the product is in perfect working order.
Check that all nuts and screws are tight.
• Check that the trimmer head and trimmer guard
are not damaged or cracked. Replace the trimmer
head or trimmer guard if they have been exposed
to impact or are cracked. Always use the
recommended guard for the cutting attachment you
are using. See chapter on Technical data.
• The product operator must ensure that no people or
animals come closer than 15 meters while working.
When several operators are working in the same
area the safety distance should be at least 15
meters.
• Carry out an overall inspection of the product before
use. See the maintenance schedule.
• National or local regulations may regulate the use.
Comply to given regulations.
1728 - 003 - 31.10.2022