Westfalia 96 20 13 Originalanleitung Seite 7

Operation
Fig. 1: Take out the insulation strip (arrow) before the first use.
Fig. 2: Snap the magnification lens of your choice into place. The magnifications
1x, 1.5x, 2x, 2.5x and 3.5x are available.
Fig. 3: The lens angle can be adjusted as desired.
Fig. 4: The LED unit can be tilted independently.
Fig. 5: Tilt the LED unit fully up to detach it for independent use.
Fig. 6: To replace the batteries open the battery compartment and replace the
spend batteries with three fresh Batteries LR 1130. Please observe correct
polarity, there are polarity symbols in the battery compartment.
Fig. 7: The temples can be changed to the headband and vice versa. Press the
buttons (arrow) and pull off the temple or headband from the glasses. To
install, slide the temple or headband on until it clicks into place.
Cleaning
 Wipe the housing of the unit with a lightly moistened cloth. Use detergent as
needed. Do not immerse the device in water or any other liquid.

Do not clean the unit with aggressive chemicals or abrasives in order not to
damage the surfaces.
Technical Data
LED:
Dimensions:
Operating Voltage:
Battery:
Operation
2x 85 mW LED, 3.200 K (warm white)
230 x 135 x 70 mm
6 V
3x LR 1130
7