Installation; Re�Ll Antiscalant - Philips X-Guard Power antiscalant AWP9820 Benutzerhandbuch

IV. Installation
1. Turn off the cold water supply.
2. Connect the cold water hose with the cold water inlet of the scale inhibitor,
and tighten the nut with a wrench. Please don't miss the gasket.
If the water hose is 3/4", attach the 3/4" adaptor to the cold water inlet
before connecting the hose.
3. Connect the cold water hose with the �ltered water outlet of the scale
inhibitor. Please don't miss the gasket. If the water hose is 3/4", attach
the 3/4" adaptor to the �ltered water outlet before connecting the hose.
4. Turn on the cold water supply. Wipe the connections with a tissue to see
if there is leakage. If the tissue stays dry, it means it is installed properly.
3
V. Re�ll antiscalant
1. Turn off the cold water supply.
2. Turn the bottom cap clockwise to remove it.
3. Take out the �lter cartridge, remove the cap, and take out the emptied
fabric bag.
4. Rinse the stainless steel mesh of the �lter cartridge with tap water, �ll the
cartridge with a new bag of the antiscalant, and put the cap back on the
�lter cartridge.
5. Put the �lter cartridge back in the scale inhibitor, and twist the bottom
cap anticlockwise until it's tightened.
1
2
12