Maintenance; Maintenance Schedule - Husqvarna BMP 265 Bedienungsanweisung

3. Make sure that the tool of the scarifying drum
touches the ground by centripetal force.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
General product maintenance
Clean the product.
Do a check of all safety devices.
Make sure that nuts and screws are tight.
Do a check of the electrical components,
the cables and the connections for wear and
damages.
Do a check of the hose connections. Do a
check of all hoses on the product for dam-
ages or leakage.
Make sure that the dust hoses are not dam-
aged and free of blockage.
Make sure that the dust collector is empty
and connected correctly.
Do a complete servicing and cleaning of the
product.
BMP 265: Make sure that the power plug and
extension cable are in good condition and
not damaged.
1814 - 002 -

Maintenance

Before you do
4. Adjust the speed to the surface. Operate with lower
speed on a rough surface.
To stop the product
1. Pull the lift lever up and turn the depth adjustment
wheel until the scarifying drum does not touch the
ground.
2. Stop the product:
a) BMP 265: Push the emergency stop button.
b) BMP 265Petrol: Turn the engine ON/OFF swith
to OFF.
3. Stop the dust extractor.
4. BMP 265: Disconnect the power plug.
5. Make sure that all moving parts are stopped.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Daily 12h after service
X
X
*
*
*
*
*
*
Yearly
*
O
11