en
Defrosting
Refrigerator compartment
defrosts fully automatically
While the refrigerating unit is running,
beads of condensation or hoarfrost form
at the back of the refrigerator
compartment. This is quite normal. It is
not necessary to wipe off the
condensation or frost. The rear panel
defrosts automatically. The condensation
runs into the condensation channel,
Fig. +. and is conveyed to the
refrigerating unit where it evaporates.
Note
Keep the condensation channel and
drainage hole clean, so that the
condensation can run out.
Cleaning the appliance
ã=
Caution
Do not use abrasive, chloride or acidic
■
cleaning agents or solvents.
Do not use scouring or abrasive
■
sponges. The metallic surfaces could
corrode.
Never clean shelves and containers in
■
the dishwasher. The parts may
become deformed!
24
Downloaded from Fridge-Manual.com Manuals
All manuals and user guides at all-guides.com
Proceed as follows:
1. Before cleaning: Switch the appliance
2. Pull out the mains plug or switch off
3. Clean the appliance with a soft cloth,
4. Wipe the door seal with clear water
5. Rinsing water must not run through
6. After cleaning reconnect and switch
Interior fittings
All variable parts of the appliance can be
taken out for cleaning.
Take out glass shelves
Fig. 4
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Condensation channel
Fig. +
Regularly clean the condensation
channel and drainage hole with a cotton
bud or similar implement to ensure that
the condensation can drain.
Take out shelves in the door
Fig. 5
Lift shelves upwards and take out.
off.
the fuse.
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
only and then wipe dry thoroughly.
the drainage hole into the evaporation
area.
the appliance back on.