Inhaltsverzeichnis
Werbung
AHM701
1. Lid
2. Internal removable water tank
3. Heater
4. Sponge disc
5. Steam tunnel
6. Acoustic overlay
7. Housing
8. Drawer with aromatherapy attachment
PREPARING THE APPLIANCE FOR OPERATION
Before starting the appliance, it is recommended to familiarise yourself with its components.
Ensure that the sponge disc is placed on the heater. Make sure that the acoustic overlay is positioned
and closed (by turning the element). Check whether the steam tunnel is fitted.
Remove all foils, cartons and protective tapes from the appliance.
FILLING THE WATER TANK
There are two methods of filling the tank.
1. After removing the tank lid (1), pour water into the tank using a bottle or other vessel.
2. After removing the lid (1), you can take out the tank (2). Lift the tank with the handle. Fill the tank
under the tap. Put the tank in the appliance body noting the position of the internal components.
USING THE APPLIANCE
Press the power switch (9a) to turn on the appliance. After pressing the power switch, the humidifier
will start to warm up. The water will start to evaporate under the influence of temperature. The
evaporation intensity depends on the selected level of humidification intensity. Pressing the button
again will make the appliance return to standby mode.
The display shows the humidity level and the ambient temperature. Due to the heating of the body,
while not maintaining sufficient air flow, the temperature indications may differ from the actual ones.
In addition, the display indicates the humidification intensity (one, two or three bars) and whether
the ionization function is active.
The humidification intensity can be adjusted using 3 intensity levels. Set the intensity by pressing the
humidification intensity selection button (9b). At higher humidification intensity, the heater uses
more power, a larger part of the water volume boils (the lower the efficiency, the quieter the
appliance works).
High efficiency
Average efficiency
Low efficiency
Press the humidistat setting button (9e) to enable the Humidistat mode. Each press will change the
target ambient humidity value by 5%. The air humidifier will turn on and off to maintain humidity
within the selected humidity level.
Press the auto button (9d) to enable the auto mode. The humidifier will try to maintain the air
humidity in the range of 50%-60% by choosing the appropriate humidification intensity.
To turn off the air humidifier lighting and enable the night mode, press and hold the night mode
button (9d). Pressing any button will restore the display.
In order to set the appliance turn-off timer, press the timer button (9c) to start the timer; each press
sets the time to the appliance turn-off from 1 to 10 hours. A long press of the button (3 seconds)
activates or deactivates the ionization function.
9. Control panel buttons
a) power switch
b) humidification intensity
c) timer / ionization
d) auto / night mode
e) humidistat
f ) cleaning
400 W
300 W
150 W
6
500 ml/h
300 ml/h
150 ml/h
Werbung
Inhaltsverzeichnis
