Information Codes - Samsung MJ26A6051 Bedienungsanleitung

INFORMATION CODES

Error Items Code
Power frequency
E1 One long beep
Error (50/60Hz) for 2 sec
Thermistor Open E21 One long beep
Error
for 2 sec
Thermistor Short E22 One long beep
Error for 2 sec.
Temperature of E3 One long beep
exhaust air too High for 2 sec
Error
HVT-I Power Error
E41 One long beep
for 2 sec
HVT-II Power Error
E42 One long beep
for 2 sec
Error Beep Cause
Power frequency is
other than 50 Hz.
Thermistor Sensor
which is supposed to
sense the temperature
of the cavity inside does
not work properly.
(Thermistor Sensor
open)
Thermistor Sensor
which is supposed to
sense the temperature
of the cavity inside does
not work properly.
(Thermistor Sensor
short)
The oven cavity
gets too hot due to
excessive operation
with no load or small
load, or due to some
blocking materials
around the Air Filter or
Air Exhaust at the back
of the oven.
The circuitry inside the
oven is not working
correctly.
The circuitry inside the
oven is not working
correctly.
Unplug the power cord plug and check if the power frequency is 50 Hz.
Plug the power cord in 50 Hz power source and see If "E1" appears. If the
error code is displayed again even after the correct power source is provided,
contact the nearest service centre.
Unplug the power cord and wait for more than 10 seconds. Plug the power
cord again. If the symptom persists, contact the nearest service centre.
Unplug the power cord and wait for more than 10 seconds. Plug the power
cord again. If the symptom persists, contact the nearest service centre.
Open the oven door and check if 1) the oven has been operating with no
load or too small load, 2) the air filter is placed in a wrong position, or 3) any
blocking materials exist around the Air Exhaust. Cool down the oven (for
approx. 30 min) under the normal temperature. The oven is back to normal
when the error code "E3" disappears and "ON" appears again in the display
window.
Unplug the power cord, remove the blocking materials around the ventilation
openings, cool down the oven (for approx. 30 min) sufficiently, plug the power
cord in again and check if the error code appears again.
If the symptom persists even when the oven is cooled down sufficiently,
contact the nearest service centre.
Unplug the power cord and wait for 10 seconds.
Plug the power cord in again and check if the error code "E41" appears again.
If the symptom persists, contact the nearest service centre.
Unplug the power cord and wait for 10 seconds.
Plug the power cord in again and check if the error code "E42" appears again.
If the symptom persists, contact the nearest service centre.
11
Remedy