Silvercrest SHBR 560 B1 Bedienungsanleitung Seite 27

Fault Cause
The fresh water
tank
The fresh water
tank
properly.
The appliance
The appliance is not
does not
completely ready for
dispensing
use.
enough clean-
ing solution.
The continuous spray
function is not activated.
The splash guard
is not fitted properly.
The rotary brush
not fitted properly.
The rotary
6
brush is not
turning.
The rotary brush
blocked.
Water is leak- The fresh water
ing from the tank
appliance. properly.
■ 24 │ GB │ IE
Remedy
Fill up the fresh water tank
q
is empty.
Filling the fresh water tank).
Take the fresh water tank
q
is not closed appliance and tighten the lid (see section
Filling the fresh water tank).
Before each use, press and hold the cleaning
solution switch
add cleaning solution to the rotary brush
so that it is ready for use.
Press the cleaning solution switch
briefly to activate the continuous spray function
and continuously apply cleaning solution to the
brush roll
7
Fit the splash guard
Manual cleaning).
Switch the appliance off and pull out the mains
6
is plug.
Fit the rotary brush
section
Remove the plug from the mains power socket.
Remove the splash guard
brush
6
Fit the rotary brush
is
back onto the appliance (see section Manual
cleaning).
Insert the plug into a mains power socket and
switch on the appliance.
Take the fresh water tank
q
is not closed
appliance and tighten the lid (see section
Filling the fresh water tank).
q
q
t
for about 10 seconds to
6
.
7
properly (see section
6
properly onto the foot
3
(see section Manual cleaning).
7
6
to clear the blockage.
6
and the splash guard
q
(see section
out of the
6
t
twice
and the rotary
7
out of the
SHBR 560 B1