Zanussi ZCAN38EW1 Benutzerinformation Seite 62

Problem
If your appliance is still not working properly after making the above checks, contact the nearest Authorised
Service Center.
Specify the model and serial number of your appliance when you contact Authorised Service Center. This
will accelerate the support received.
62
Possible cause
Many products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The lid was opened too often.
The SUPER function is switch-
ed on.
Products to be frozen are
placed too closely to each oth-
er.
The appliance is positioned
near the heat source.
Solution
Store less products at the
same time.
Defrost the appliance. Refer to
"Care and cleacning/Defrost-
ing the appliance" chapter.
Open the lid only if necessary.
Refer to "Control panel/SU-
PER function" chapter.
Make sure that there is cold air
circulation in the appliance.
Refer to "Installation/Location"
chapter.