Selecting The Temperature; Select Heat Setting; Switching On The Fan - Silvercrest SKD 2300 D5 Bedienungsanleitung

Selecting the temperature

NOTE
► The temperature measurement is made by the temperature sensor
take some time until the whole room has reached this temperature.
♦ Press the temperature unit selection button (°F / °C)
ture display to °C or °F.
The selected temperature unit
♦ Press the arrow button
maximum of 37 °C (99 °F).
The selected target temperature
♦ Press the arrow button
minimum of 5 °C (41 °F).
The selected target temperature

Select heat setting

The heat setting determines how quickly the appliance warms up.
The appliance has three heat settings:
■ Level 1: 1000 watts
■ Level 2: 1300 watts
■ Level 3: 2300 watts
♦ Press the button to select the heat setting
desired heat setting has been set.
The selected heat setting

Switching on the fan

The appliance has a fan which can be used to distribute heated air throughout the
room more quickly.
♦ Press the fan button
If the fan is running, the „Fan" symbol
NOTE
► If the fan is switched off, the heat is concentrated more around the appliance
and is not distributed so quickly around the room.
│ GB │ IE │ NI │ CY
■ 12
13
is shown on the display
15 32
or to increase the target temperature
19
is shown on the display
16 29
or to reduce the target temperature
19
is shown on the display
10
is shown on the display
14
27
or to switch the fan on or off.
11
appears on the display
7
28
23
or to set the tempera-
2
.
2
.
2
.
24 26
or repeatedly until the
2
.
SKD 2300 D5
. It may
19
to a
19
to a
2
.