Initial Use; Switching The Product On / Off; Installing The Product - Parkside FCL-76003LI Bedienungsanleitung

You can mount the product on a tripod or a wall, or hang it up using
the fold-out hook
3561_2010_par_LED-Arbeitsstrahler_A6_content_OS.indd 27 3561_2010_par_LED-Arbeitsstrahler_A6_content_OS.indd 27

Initial use

Switching the product on / off

Lay the mains cable in such a way that nobody will step on or trip
over it.
To switch the product on, plug the mains plug
installed mains socket.
Note: Insert the mains plug
guarantee the protection against splashing water.
To switch the product off, remove the mains plug
mains socket.

Installing the product

.
6
To mount the product on a tripod (not included in the scope of
delivery), use the fixture for tripod installation
described in the instructions for your tripod.
To mount the product on a wall, use the fixture for wall installation
. Information on suitable installation material can be obtained
8
from specialist stores.
Note: Pay attention to the cable length (3 m) when mounting the
product on a wall.
If you would like to hang up the product using the fold-out hook
make sure that the chosen hanging location is suitable for bearing
the weight of the product (approx. 955 g).
Note: Pay attention to the cable length (3 m) when mounting with
the hinged hook.
4
into an IPX4 plug socket to
4
7
into a properly
from the
4
. Proceed as
,
6
GB/IE 27
24.03.21 11:3 24.03.21 11:3