Specifications - Hama CC 718L Bedienungsanleitung

PAPER BLOCKAGE AND OVERLOAD
PROTECTION:
The CC 718L has a motor with an overload
protection function. The normal operating cycle
for uninterrupted shredding activity is 3 minutes
continuous operation followed by 25 minutes
switched off. The shredder may switch itself off
automatically in the following cases:
1. If the shredder is used for more than three
minutes at a time.
2. If it becomes overloaded due to more than
seven sheets of paper being fed into the
shredder at a time, or if the paper is not fed
into the shredder evenly.
3. For your own safety, if the paper basket is
removed while the shredder is running.
The fi rst two cases can trigger the automatic
overload protection function which interrupts
the power supply. If this is the case, proceed as
follows:
1. Remove the plug from the socket and wait
at least 25 minutes until the overload
prevention function resets. Remove all
remaining paper from the shredder or cut it off
appropriately.
2. Then connect the machine to the mains again
and set the switch to REV. Using the reverse
function, pull the paper trapped in the cutting
rollers out of the top of the shredder. You can
then set the switch back to AUTO.
3. If the switch is set to „AUTO" and the paper
feeder is clear, the shredder is now ready to
use again.
All manuals and user guides at all-guides.com
CLEANING AND CARING FOR THE CC 718L:
This shredder requires regular care (monthly
for normal use). You should also oil the slitting
mechanism. If you do not do this, the motor noise
can become louder, blockages can occur more
frequently, the slitting capacity can decrease or it
might not work any longer.
Proceed as follows to oil the slitting mechanism:
1. Apply the appropriate oil to the rollers below
2. Set the switch to AUTO and let the rollers
3. Then set the switch to REV and let the
4. Repeat steps 2 and 3 about three more times.

SPECIFICATIONS:

- Slitting sizes:
- Slitting capacity: 7 sheets
- Slitting speed: 2.38 m/min.
- Max. feed width: 220 mm
- Mains connection: 220-240 V~
- Dimensions: 365 x 440 x 200 mm
the paper feed.
rotate for approx. 3 seconds.
shredder run for another 3 seconds.
- Paper: 4 x 23 mm (cross cut)
- CD: mm (strip cut)
- Plastic card: mm (strip cut)
5