Operation - Westfalia 96 11 88 Originalanleitung

Before first use
 Make yourself familiar with the device before using it for the first time.
Observe the safety instructions and only use the device in accordance with
these instructions.
 Remove all packaging components from the device parts.
 Clean the container as described in the "Cleaning" chapter.
Inserting the Batteries
1. Hold the lower part with one hand and turn the housing cover counter-
clockwise with the other hand to open the bayonet lock. Then pull the cover
up and away from the container.
2. Pull the drive unit up and off the lower part.
3. Insert 6 type LR03 (AAA) batteries into the battery compartments on the
drive unit. Pay attention to the correct polarity. For help, you will find the
corresponding battery symbols in the battery compartments. Use only
alkaline batteries.
4. Fill the container up to approx. 80% with pepper or salt.
5. Place the drive unit back on the container.
Make sure that the arrow on the drive unit
aligns with the closed padlock symbol on the
container and that the contact pins point to
both screws on the container. Press the drive
unit firmly onto the container.
6. Put the housing cover back over the drive unit. The arrow on the housing
cover must match the open padlock symbol on the container. Turn this
clockwise tightly back onto the container.

Operation

 Remove the cover on the underside of the device.
 Press and hold the ON / OFF button on top of the device to operate the
grinder and switch on the built-in light.
 You can set the desired grinding degree using the knurled screw at the
bottom of the device:
Clockwise = finer,
Counter clockwise = coarser.
If the grinder no longer rotates with a very fine setting, select a coarser
setting. If the grinder still does not turn, it may be clogged. Then select the
Operation
9