Measurements - Silvercrest SPO 55 Gebrauchsanleitung Und Sicherheitshinweise

The memory of the pulse oximeter has over
100 storage slots. If these are all full, the
oldest value will be overwritten.
To reset the device to its factory settings,
proceed as follows:
1. Remove one of the two batteries inserted
into the device.
2. Press and hold the function button
and reinsert the battery.
3. After inserting the battery, hold down
the function button
seconds. If you have successfully
2
for a further 5
2
followed the instructions, "RESET " will
appear in the display.

Measurements

Slide one finger into the finger opening
on the pulse oximeter. Hold the finger still
(Fig. F).
Press the function button
meter will now begin the measurement. Do
not move during measurement (Fig. G).
After a few seconds the display
your measurements (Fig. H).
3
. The pulse oxi-
2
will show
1
GB/IE 77