Transportation And Storage; Transportation Of The Product; Technical Data - Husqvarna PP 492 Bedienungsanweisung

Error code Error message
There is high motor tem-
1
FXX08*
perature.
There is low input volt-
F0112
age.
There is high input volt-
F0113
age.
FXX14* Error in the tool temper-
ature sensor.
There is a hardware
F0118
fault.
The temperature in the
F0119
product is too high.
F0130 There is a general error. The blade does not move freely.

Transportation of the product

• Make sure that the product is safely attached during
transportation to prevent transport damage and
accidents.
• Always stop the product and disconnect the power
cord before you move the product.
• Always disconnect the power tool and the power tool
cord before transportation.
Storage of the product
• Keep the product in a locked area to prevent access
for children or persons that are not approved.

Technical data

Rated voltage
Max. output, kVA
Rated current, A
1
XX: different numbers on different tool that is connected to the power unit.
967 - 002 - 11.06.2021
Possible faults
The motor temperature is too
high.
The input voltage is too low.
The input voltage is too high.
Stop or short circuit in the tem-
perature sensor.
N/A.
The product is too hot.

Transportation and storage

Technical data
Possible procedure
Increase the flow of water coolant. Use
clean water to prevent blockage in the
water channels. Refer to
ta on page 17 for specifications for
water flow, temperature and pressure.
Refer to the minimum voltage input in
the manual.
Refer to the maximum voltage input in
the manual.
Speak to your servicing dealer.
Speak to your servicing dealer.
Increase the flow of water coolant. Use
clean water to prevent a blockage in
the water channels. Refer to
data on page 17 for specifications for
water flow, temperature and pressure.
Stop the product and release the
blade.
• Keep the product in a dry area.
• Make sure that the temperature is not lower than
-25°C (-77°F) and not higher than 50°C (122°F).
• If there is a risk that the water will freeze, the product
must be drained of all remaining water coolant. Tilt
the product to drain the water coolant from the water
connector outlet.
380-480
20
16/25/32
Technical da-
Technical
17