Anleitung LEF 200 mehrsprachig
GB
If the power cable suffers any damage,
it must be replaced by a specialist in
order to rule out all risks.
Fan speed
The unit has two speed settings. Press the
button to change over to high speed. For
quiet operation, particularly at night, set
the switch to low speed.
Operation
Insert the power plug in a suitable 230V ~
50 Hz socket-outlet. Press the button to
select the required moisture setting or
activate „CNT" = continuous moisture
extraction.
To switch off the unit, turn the switch on
the panel to „OFF". The power indicator
must now go out.
Emptying the water tank
When the water tank is full, the unit
switches off automatically and the water
level indicator lamp shines with a red light.
Empty the tank as follows: Raise the tank
slightly by its handle and carefully pull it
out.
After emptying the tank, return it to its
proper place.
10
25.10.2001 9:55 Uhr
Options:
For continuous or lengthy operation,
please note the following:
1. Remove the water stopper at the rear
of the housing. Connect the water hole
to a suitable 6 mm water pipe.
2. Pull out the water tank and insert the
water stopper (taken from the rear of
the housing) in the hole where the tank
is otherwise connected.
3. Please make sure that the condensed
water can flow away and that the water
pipe is securely fastened.
4. Re-insert the water tank.
5. Important: In very cold weather you
should take precautions to ensure that
the water does not freeze.
Cleaning the air filter
Clean the filter with a vacuum cleaner or
by tapping lightly. Very dirty filters should
be gently washed in warm water and then
thoroughly dried.
Seite 10