Hama 00040074 Bedienungsanleitung Seite 8

Note
• Press the [EXIT] button to exit Setup mode without saving a code. The status
LED ashes 3 times and then goes out.
• If no device selection is made, the last device selection made is automati-
cally used.
• A maximum of 350 codes of the most common devices can be stored in the
internal memory. Due to the numerous AV devices available on the market,
it may happen that only the most common main functions are available. If
this is the case, repeat steps 5.2.1 to 5.2.5 to nd a more compatible code.
A code may not be available for some speci c device models.
5.3 Automatic code search
The automatic code search uses the same preset codes as the manual code search
(5.2). However, the universal remote control automatically searches the codes
until the device to be operated shows a response. For example, the device to be
operated switches off ("POWER" button) or changes channel ("CH+/CH-" buttons).
5.3.1 Switch the device you wish to operate on.
5.3.2 Press the "SETUP" button until the LED lights up continuously.
5.3.3 Use the device button to select the device to be operated (e.g. TV).
If the selection is successful, the LED flashes once and then lights up
permanently.
5.3.4 Press the "CH+/CH-" or "POWER" button to start the automatic code
search. The LED flashes once and then lights up permanently. It takes 6
seconds for the universal remote control to start the first search.
Note:
Setting the search speed
• The default setting for the search time per code is 1 second. If this does not
suit you, you can change to a search time of 3 seconds per code. To switch
between search times, press "CH+" or "CH-" within the 6 seconds before
the automatic code search starts.
5.3.5 The LED confirms the respective code searches with a single flash.
5.3.6 As soon as the device to be operated shows a response, press the "SETUP"
button to save the code and exit the code search. The LED goes out.
5.3.7 Then test the remote control and check whether the desired functions
can be controlled. It is possible that the first code found is not the most
suitable, and possibly not all functions are available. In this case, repeat
steps 5.3.1. – 5.3.6.
The code search starts with the next code following the last one saved.
5.3.8 To cancel the automatic search during the search process, press the "EXIT"
button.
Note
• If all codes have been searched without success, the universal remote
control exits the automatic code search and automatically returns to
operating mode. The currently stored code remains unchanged.
6