Panasonic EY47A1 Bedienungsanleitung Seite 14

WARNING
EN
• Do not handle the rechargeable
power tools in the following way.
(There is a hazard of smoke
generation, fire, and rupturing)
- Use or leave in places exposed to
rain or moisture
- Use submerging in water
Symbol
V. ASSEMBLY
WARNING
• To reduce the risk of injury, always
remove battery pack before changing
the blade.
• Do not inhale any smoke emitted
from the tool or battery pack as it
may be harmful.
Inspection before use
• Has the correct jigsaw blade been
attached for the object to be cut?
• Has the correct stem shape and
thickness of the blade been mounted?
• Check if the blade is fixed securely?
• Check if the blade is cracked or
broken.
• Check that there are no foreign objects
in the object to be cut.
Meaning
Volts
Direct current
No load speed
Revolutions or
reciprocations per
minutes
Electrical capacity of
battery pack
To reduce the risk of
injury, user must read
and understand
instruction manual.
For indoor use only.
Attaching and removing
the reciprocating saw
blade
WARNING
• Be sure to remove the battery pack
before performing the blade
replacement procedure, which
includes preparation, inspection,
and replacement steps.
Failure to do so may result in an
accident in which tool operation is
triggered inadvertently.
• When pulling the reciprocating saw
blade, be sure to pull the back side.
When choosing a reciprocating saw
blade, select a blade that protrudes
sufficiently far from the protective shoe
beyond the material being cut after the
stroke length (14 mm) has been
subtracted [Fig. 1].
Attaching
1. Insert reciprocating saw blade into
blade clamp. [Fig. 2]
2. Insert the reciprocating saw blade
while holding the locking sleeve in
the rotated position. [Fig. 3]
The blade can be attached facing up
or down as appropriate for the type of
work being performed. [Fig. 4]
3. Let go of the locking sleeve.
• An integrated spring will return the
sleeve to its position automatically,
locking the reciprocating saw blade
in place.
• Grip the back of the reciprocating
saw blade and pull it two or three
times to verify that it is securely
attached. [Fig. 5]
• Check that the temperature of the
blade has dropped sufficiently, and
then remove the blade.
Removing
1. Rotate the locking sleeve.
2. Remove the reciprocating saw blade.
– 14 –