Features; Special Features; Lamp Test - Bosch Rexroth PSI 6 147-Serie Typspezifische Anleitung

42/50 Bosch Rexroth AG

Features

7 Features
Sequence standard 1000 Hz (sequence parameters in milliseconds)
I/O-board
 Double start, double pre-piston stroke, relay exit
 Double start, double pre-piston stroke, relay exit
(Details refer to Tab1. Required and supplementary documentation,
Rexroth PSI6xxx Medium-Frequency Inverter Instruction Manual).
7.1

Special features

The welding controller features the following specifics:
 Control is prepared for a networking with an Interbus-PMS or a professional bus
cbm or ethernet assembly.
 With pressure output
 Without pressure feedback
 24 VDC Stop Circuit open / no 24V, fault is automatically reset
 The mains voltage is always checked, the error message: Synchronization fault,
is self acknowledging.
 With start tip dress request function
7.2

Lamp test

When lamp test is selected, lamp test activates the following outputs:
Tab. 10: Outputs for lamp test
Bits Outputs
A 02 Timer control ready
A 03 Timer control fault
A 04 Weld fault
A 07 Pre-warning 1
A 08 Pre-warning 2
A 09 Tip Life expired 1
A 10 Tip Life expired 2
R911332846 | PSI 6xxx.147xx