Bosch Indego XS 300 Installationsanleitung Seite 18

With enough required space and in the correct orientation.
3.4
The docking station for your Indego needs to be placed at the side of your lawn, in a corner or on the edge.
It is important that you leave enough space around the docking station, as indicated in the image below, and that the
docking station is facing in the correct direction. Failure to do so will prevent your Indego from docking correctly.
The house symbol should face towards the areas outside of the perimeter wire, whilst the tree symbol should
point towards the cutting area.
Corner placement
30 cm > 100 cm
Edge of the lawn placement
100 cm
!
The docking station is an important reference point for your Indego. Any deviation from the installation as shown in
the pictures may result in issues with the navigation/performance of your Indego and should therefore be avoided.
34
150 cm
30 cm
> 100 cm
150 cm
30 cm
Your Indego moves in a clockwise direction to the docking station. Any other positioning will prevent your mower from
docking correctly.
Feed the perimeter wire
3.5
through the cable duct underneath the
docking station as indicated by the arrow
until it appears on the other side.
Carefully strip
3.6
10–15 mm of insulation off the wire.
Connect the wire
3.7
to the black connector point.
Ensure that no stripped wire is
visible outside of the connector
points.
Fix the 4 docking station
3.8
screws in place with the hex key.
GB
35