Cleaning & Maintenance; Storing The Appliance - Bosch Sensixx B22L Gebrauchsanleitung

5.3. Rinsing the iron steam
chamber

See the leaflet sides
E
Caution! Risk of burns!
This procedure helps to remove scale particles
out of the steam chamber.
This cleaning procedure may be performed
occasionally (approximately once a year), when
after a long period of use with very hard water,
scale particles start to come out of the soleplate.
1 Ensure that the iron is cooled down.
2 Set the temperature selector (16) of the iron to
the "min" position.
3 Fill the tank with tap water.
4 Plug in the mains cable and set the main
power switch (13) to the "I" position.
5 Wait until the "steam ready" indicator lamp (9)
lights up.
6 If the steam station has steam regulator (11*),
set it to the maximum position
7 Hold the iron over the sink or a container to
collect the water.
8 Press the steam release button (17) and
gently shake the iron. Boiling water and steam
will come out, carrying scale and or deposits
that might be there. This could take
approximately 5 minutes.
9 Set the temperature selector (16) of the iron to
the "max" position, without pressing the steam
release button (17). The water in the steam
chamber will start evaporating. Wait until all
the water inside the chamber has been
evaporated.
J To clean the soleplate, immediately rub off any
residue by running the hot iron over dry cotton
cloth.
Cleaning & Maintenance

See the leaflet sides
E
Attention! Risk of burns!
Always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cotton cloth.
3. If the soleplate is soiled with dirt or scale, clean
it with a damp cotton cloth.
4. If the cloth is synthetic, it may melt due to the
high temperature on the soleplate (20). Switch
20
BOSCH
All manuals and user guides at all-guides.com
5. Never use abrasive products or solvents. To
1. Always allow the appliance to cool down
2. Set the main power button to the "0" position
3. Empty the water tank.
4. Model dependent: Place the iron on the iron
.
5. Store the mains cable in the storage
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
• Start by ironing the fabrics that require the
• Regulate the steam according to the selected
• Try to Iron the fabrics while they are still damp
• If the fabrics are damp enough, turn off the
off the steam and rub off any residue
immediately with a thickly folded, damp cotton
cloth.
keep the soleplate (20) smooth, you should
avoid hard contact with metal objects. Never
use a scouring pad, or chemicals to clean the
soleplate.

6. Storing the appliance


See the leaflet sides
before storing it.
(the red light will go off) and disconnect the
mains cable.
pad (2), standing on the soleplate, and fix it by
inserting the tip of the iron into the front slot
and moving the lock lever (14*) against the
heel of the iron.
Use the iron´s handle when moving the
appliance.
compartment (5) and the steam hose in the
storage fixing (3). Do not wrap the cords too
tight.
Tips to help you save energy
lowest ironing temperature.
Check the recommended ironing temperature
in the label on the garment.
ironing temperature, following the instructions
in this manual.
and reduce the steam setting. Steam will be
generated from the fabrics rather than the iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
programme.
steam regulator completely.
* Model dependent