Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Dear Customer,
For assembly, please lay out this assembly guide in
a convenient place. All numbers in brackets ( ) refer
to the outline drawings.
1
11.
Insert the rounded side tubes (30) into the
pockets of the side plastic (53) from above. At
the front there are no additional holes for the
rounded side tubes (Fig. 1).
12.
Insert the side struts (33) through the lower
pocket of the side plastic (53). Screw the side
struts (33) on the outside of the rounded side
tubes (30) and also screw the support tube (34)
with the telescopic tube (10) to the outside of
the front rounded side tubes (30). Thumb
screws (39) for the support tube (34) face
outwards (Fig. 2).
13.
Mount the ridge bar (32) in the center on top of
both side halves. Mount the upper cross tube
(31) on the side halves. To do this, pierce the
plastic of the side halves over the mounting
holes (Fig. 3).
14.
Fit the plastic of the plastic pocket B to the
length of the cross tube (31) and insert the
cross tube (31). The mounting holes are not
covered with plastic. Insert the cross tube (7)
into plastic pocket A (Fig. 4).
15.
Screw in the lower cross tube (31) at the front.
If you plan on using ground anchors (36), then
screw these in as well. Screw the lower cross
tube (31) in plastic pocket B to the rear side
halves. Screw in the ground anchors (36) if
necessary (Fig. 5).
16.
Mount the non-colored, short wire-ties (37) to
the side halves with a little tension (Fig. 8).
17.
Pull the cover over the frame (Fig. 5).
18.
Insert the rounded side tubes (3) into the
plastic pocket and screw down (at the top) on
the ridge bar and below with the cross bar (7).
Pierce the plastic over the mounting holes (Fig.
6).
19.
Mount the cross strut (6) to the cover flap under
the plastic. The plastic rests on top of the cross
strut (6). Pierce the mounting holes (Fig. 7).
10.
Mount the non-colored, short wire-ties (14) to
the cover flap with a little tension. Pierce the
mounting holes (Fig. 8).
11.
Screw the telescopic tubes (10) with the
rounded side tubes (3) to the cover flap. Pierce
the mounting holes (Fig. 8).
12.
Screw the handle to the cross bar (7). Pierce
the mounting holes (Fig. 8).
6
13.
Fasten the plastic to the tubular frame using
the enclosed plastic clips.
The plastic-covered cold frame is now fully
assembled and can be anchored to the ground with
the ground anchors.
Important note:
In order to protect the plastic, we recommend taking
it off of the tubular frame before the onset of winter
(frost), then cleaning it, drying it, and storing it
together with the plastic clips in a warm place until
next spring.
The warranty does not apply to the plastic cover!
Replacement plastic can be ordered by quoting
replacement part number 36.023.20.01.
Werbung
